Follow

LOCATING YOUR SPARK ON THE NETWORK – WINDOWS™

1. Having launched Studio Monitor, click the small menu (‘hamburger’) gadget at upper left to open the application menu. Among other things, this menu displays all NDI sources detected on your network.

2. Shortly, you should see a new main entry named NEWTEK-CONNECT added to the menu. Rolling the mouse pointer over this label shows the individual names for the NDI output channels of any Spark units detected on the network.

Hint: Detection of newly-connected NDI sources can take a few moments; in network settings with a great number of NDI sources available, a complete refresh of the source list can take a minute or even more. When the sub-menu lists multiple NDI channels with the same name, the device IP addresses are shown to further identify them. (NDI users seldom need to bother with mundane matters such as IP addresses. )

Select the newly listed channel for the Spark unit you wish to configure. In a few moments, its video output will appear in the Studio Monitor window. (Figure 1-4 shows output from a Spark that has no video source connected.)

3. For NDI sources that supply a configuration web page, a small configuration (gear) icon appears at lower right when you roll the mouse pointer over the Studio Monitor window – Figure 1-5.

4. Click the gear to open the corresponding web page, popping up a request for you to enter login credentials (Figure 1-7).

Note: The Microsoft Edge™ web browser is not fully supported at this time. On Windows platforms, please another modern web browser or Internet Explorer™. Also, see Section 1.5.1 for details of another way to locate your Spark unit on the network if you have difficulty with the method detailed above.

 

SECTION 1.4 

For more information please download the entire document at http://new.tk/NCSGuide 

Was this article helpful?
0 out of 1 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.