Follow

NETWORK SETTINGS

Controls in the Network Settings section will be familiar to anyone who has connected a computer or mobile device to a network, and thus require little explanation.

Typically, your network will be configured to automatically supply IP addresses to devices you connect to it by means of a DHCP server. Your camera’s IP Address resolution method is set to Dynamic by default, to take advantage of this scheme. To assign a static IP address to your PTZ1, change the IP Address setting to Manual.

NOTE: Should the default IP Address mode (Dynamic) fail to provide a usable IP address within a minute or two of powering up – as when an active DHCP server is not found on the network – PTZ1 will automatically switch to Manual mode and attempt to connect using a static IP address. The default IP address is 192.168.100.168

 

 

For more information please download the entire document at http://new.tk/PTZ1Guide

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Article is closed for comments.