NC1 IO Units Restore Process

The NC1 IO units can be restored much like other Tricasters, however, this may not have been included in the Users Guide, so the steps for NC1 IOs using Windows 10 are outlined below:


** Do NOT power off, restart or unplug the system once the restore process has started.


-Boot up or restart your NC1.

-Before launching into Windows, you should get this screen:


-Click on "Backup and Restore"


-This should then take you to the following screen:

-Highlight "Restore System Partition to Factory Defaults"


-The system will eventually stop on this screen:​ 


- Type "Yes" (with a capital 'Y') and hit enter. 

-Once the restore has finished, power the device off for 15 seconds or so, then boot it back up.





Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request


Article is closed for comments.